EL wire modification. No glue



  • https://youtu.be/jqPb9WRpmZc

    Routered foot pads to accept and hold EL wire. Modified GoPro mount to hold battery case.



  • looks good. I was thinking about this mod, still am. I like the routed inset look.



  • Thank you
    I do like the clean look of not seeing the battery case but it is used at night and not an issue for me.. I didn't want anything totally permanent like glue on the board and use the GoPro mount for other mods too.
    The notch in the foot pads works perfect when it is slightly less than the diameter of the wire so the screws squeeze it in place. You can also cut the excess EL wire, just be sure to cap the end.


Log in to reply
 

Looks like your connection to Onewheel Forum was lost, please wait while we try to reconnect.