Okay Drew here you go! Pretty in pink?
One is good for the average joe (straps), while yours is better for the DIY person with a bit of skill...at least that's what it seems like.
I'll have to see if there IS a pink filament I can use...I know there is purple. But pink - let me check.
Edit: there is a pink color! It's like the blue / green above that's translucent, like a gummy bear. I'll order a roll.
I have no idea, sorry! Not that it's a "solution" per se, but you can literally put this on or off in about 2 minutes (btw, much easier & faster with a hex driver with a handle instead of a right angle allen key). Four bolts all with the same hex key size as the rest of the OW board. So if it doesn't fit, you can always throw it on if needed at a moments notice once you get where you are traveling to.
I feel like a large capacitor (or more than one) in line with the battery could also help (instead of using another entire battery to increase capacity). We use these capacitors all the time in high powered RC stuff so that the motor isn't starved for power during high powered maneuvers. Essentially it's like a small storage tank for charge that is constantly filled, but when the motor asks for too many amps or there is voltage sag, the capacitor releases it's energy quickly to "fill in the gaps" for power delivery. I'm sure there are some already in the board, but I wonder if more / higher capacity ones may also make a difference.
Hmm...I think @OW-Miami 's solution with the steel strap is easier, perhaps stronger, and less trouble for sure to install.
Looks like your connection to Onewheel Forum was lost, please wait while we try to reconnect.