@kolinko Sure!
Here is the main table, rubber to keep the seal tight once under pressure.
This is layer one out of 3, with about 1200 small holes that sucks the vacuum later.
This is from the side, where you can see the layers, its basiclly a top part, a frame around the table, and a bottom with just one hole to the plumbing.
The feets are just so I can position the table somewhere, attach the vacuum without having all the weight on the plumbing and the vacuumer hose.
Attaching my vacuumer.
The essential frame where I will put my piece of thermo plastic later.
Ill open it up, part 1 and part 2.
I put my piece of ABS, Lexan, polycarbonate plastic or whatever I need to use here (this is NOT the correct plastic, I put it there to show), put em together with the bolts and put pressure around the edges so that it becomes air tight.
These wood plugs are just to guide the frame to the correct place within the table.
Put my mold here, which will be my fender later on =)
Ill heat up the plastic with a infra heater, about 2000 watt in a form ill build later. Its going to be about 3 feet high cube, where I put my form on top of, with the plastic attached, and the heater at the bottom, it will slowly become warmer and softer. When im done Ill move it back to my table with the vacuumer turned on.
And when the plastic cools down below the softing point, the plastic will be a hard mould of the fender, ill remove it, and attach it to my OneWheel :)
Hope that explains it. And also, I have no idea what Im doing, its my first time doing this =)
I might put the frame on a hinge unless I get a good result from this moving back and forth. We will see.
Here is a video. https://www.youtube.com/watch?v=lEvNI3ZgeBY
Starts from about 1:10.
