Tips for Newbies - Enter Them Here...



  • @hekkubus
    Perhaps the most important advice you got there.
    Though I was under the impression that while Onewheel is moving, it's okay to move foot, I don't take that chance, nor I'm able to.
    I'm still able to slide my foot slightly to get into a comfortable position from time to time, while sensors are constantly pressed.
    I found that flat sneakers are best to use.
    Going uphill may involve slight bending the back knee to maintain center of gravity, meaning wheel straight under body as Thegreck often mentions.





  • @thegreck

    Yep, worth copying and pasting:

    Oops, it did that funny format again. Deleted.



  • @SeaP90d One thing to remember is that once you're riding over .5mph you can remove pressure from ONE of the sensors (there are 2 sensors: one on the toe and one on the heel) without anything happening. This is good to know if you need to adjust your footing a bit while riding.

    But be careful, because removing pressure from BOTH sensors will immediately disengage the motor (because it thinks you fell off the board) and send you flying through the air.



  • @thegreck said:

    once you're riding over .5mph you can remove pressure from ONE of the sensors

    I did NOT know this...I thought you always had to be covering both. Great info!



  • @Aswellie You can test it out by doing something I like to do sometimes as a show-off type of dismount:

    From a stopped position, start the OW moving slowly away from the sensor side of the board, and while you're rolling, move your toe off the top sensor. Then level the deck and let the OW slow down. Nothing will happen until it hits that magic .5mph, at which point it'll tip over and you can step off.



  • Re dismounts here's one we wish we knew from the start, ROTATE YOUR FOOT AT THE HEEL to get your toe off the sensor before lifting your heel. Do it this way and you'll be cool with elegant non-spazzy dismounts 100% of the time. Do it the other way and just lift you heel without rotating your foot (in reliance on the supposed split sensor thing=>Insert Text Here<=) and half the time you'll find yourself stuck in an awkward ballet pose with one foot on your tip toes but the board still not disengaged.



  • Use your back foot to help you make tighter turns. If you're like me, you neglect to use this foot as much when turning. I know it sounds dumb because obviously you use both feet to make turns, but most of the time I've found that I'm being lazy with my back foot when trying to make my turns (especially toe-side turns). Using my back foot too helps me make the turns quicker, too.



  • My top tip for newbies and experienced riders....wear a helmet...always!



  • My top tips:

    • always wear a helmet!

    • always place your forward foot on the sensor pad side - back foot on the non-sensor side

    • Don't look down - look where you want to ride!


Log in to reply