OW Footpad connector PINS
Rno last edited by Rno
had issues with a OW Pad, so i went into finding the Pins used and made sure problem was not with the Board.
I figure sharing this will help retro-fit OW+ pads to OW.
Really happy to participate into the retrofit of OW+ newest Pads towards "good old" OW ;-)
SeattleCommuter last edited by
Just tested on the OW+ Footpads and the wiring is the same.
It's closed by default and circuit opens when the sensor is pressed
Tartopom last edited by
yes, basically if you buy OW+ footpads and bumpers, you can then make a OWv1+ :P