Do not ride at high speed!

  • @OneDan that’s kind of concerning, considering this is their forum.

    Shows a lack of interest in their own community and any care for their own consumers and enthusiasts...

    That’s bad JuJu, imo.

  • @causticgrip
    Typically they only post for news and announcements. I'm guessing they don't staff to support the OW forum... Facebook groups are extremely active as is Reddit for OW stuff.

  • @skyman88 Can you fill me in on regen shut-offs? First I've heard of that one.

  • @scrapdo Battery regen-recharges when braking downhill (and it's ALWAYS braking somewhat, unless you are going full tilt straight downhill like a madman).

    BUT, battery can't be charged past 100% - that'd wreck the battery. So, if battery is at 100% and you try to go downhill, board won't - it shuts off, to protect the battery. You need to go uphill a bit and drain the battery down a little first.

  • @Glyph that’s a serious design flaw. And a dangerous one. If that is really present it needs to be eliminated. Regenerative breaking should not be shutting off the motor once 100% is achieved. It should have some algrythm to simply stop any additional charge to be applied until 2% is lost.

  • @causticgrip You'd think. I'm not sure why that's not the way it works. The board's external charger is smart enough to "know" once the battery's full (the LED turns green) so it doesn't seem like that big of a technical challenge to me, but what do I know? I live somewhere pretty flat, so it's never an issue for me.

  • @Glyph @causticgrip The onewheel doesn't have normal brakes, so it has to use regenerative braking. When it does that, it has to store the power somewhere. If it doesn't it could overheat. This means you either just have to not be at 100% when going down a hill, or your board overheats and shuts off anyway. Either way the board would shutoff eventually.

    The difference between the charger and regenerative braking is the charger just stops producing power. Whereas the regenerative braking continues to generate power because the rider decides to keep going down a hill.

  • @scrapdo
    See other comments... it's also in the manual.

    If you haven't read the following... it's worth your time:

  • There are some eskates that have load resistors so the excess regen power can be sent to the resistors when the battery is full.

    I live with a downhill start on my daily commute so never charge above 98% to avoid it. Its really not a big deal once you read the manual to understand the limits and warnings from FM.

    For me load resistors would just add weight and complexity to protect for a scenario which only occurs for a very short duration of any ride. I like FM's approach to keep it simple.

  • @stinkyface If they don't add a LOT of weight, it could be worth it. The board's already damn near thirty pounds. But if it's any more than a few ounces, or if there is no place to put them, or if adding them makes the board's systems much more complex and prone to issues, I agree with you, not worth it (to me, a guy who lives in a flat city).

Log in to reply