Costum skid plates.. what dimensions?



  • i know that people here have made costum skid plates to protects the bottom side of your OW..

    but can someone give me the dimensions of the plates? cant find it anywhere :#



  • I would recommend purchasing a second set of bumpers with your order, They're not difficult or particularly expensive to replace and take quite a few bad hits to get roached badly. I've had thoughts about custom skid plates, but the most I plan on doing is adding Fangs. It gets beat up. That's just going to happen. I use satin spar varnish to touch up the plywood, basic blue Sharpie (rubbed in before it dries) to disguise scratches to the aluminum and (2) layers of 1" Gorilla duct tape about 6" long to protect the aluminum edges near the center (top and bottom).



  • @E-Wave_I i allready bouight but i saw other people on this forum who made diy protection for ur battery.. so i was hoping to get an answer like how they did it.



  • @geilecharlie said in Costum skid plates.. what dimensions?:

    i know that people here have made costum skid plates to protects the bottom side of your OW..

    but can someone give me the dimensions of the plates? cant find it anywhere :#

    hmmm, try checking under your board for dimensions.
    Pretty sure its there. When I use my tape measure I always find the dimensions there right under my board.

    Hope that helps.

    LOL!



  • @fruitygreen amazeballs.