Has anyone swapped the foot boards? Or moved sensor?
@rue1013 you don't need to tag someone if they started the post
@rue1013 the sensor isn't stuck to the grip tape. The blue rectangle area where the sensor is located doesn't have glue on it... If it did the sensor would be stuck on. So when you angle the sensor the tape has to be angled too and not stuck to the sensor..
germx last edited by
@njcustom Pretty sure this would be a bit harder than just swapping them. As the electronics, and the cable to connect it all is on the "light side".
Guess you'd have to hack some kind of cable extension to the frame for that to work.
I still think that bigger sensor would be the best thing ;)
@germx it shouldnt be to hard extending the cable.. But I would much rather have a larger sensor
rue1013 last edited by
Thanks for the good info.... @njcustom
mrb last edited by mrb
i want to revive this idea on the forum. i want one sensor in the front and one in the back. am i missing something?
mrb last edited by
gotta tag you cause i like your style kid--hooahh
@mrb thank you! I bet the 2 sensor idea would work..
sonny123 last edited by sonny123
Back sensor is a personal preference and can be done by extending the wire.
I thought of front angled sensor pad but wasn't enough room to turn. Certainly can be done with some modification.
But I was able to move both pads 1" further out. Working fine for me.
kbman last edited by
Two sensors/ larger sensor for sure