I ride in the cold a lot but mine remains in the house until I ride then it goes back inside to charge. I’ve not had one problem.
I wobbled quite a bit as a noob to any type of boarding when I started. As I got used to it the wobbled stopped. I still get some when I start to fatigue.
Would you be willing to share how you did it?
22 was my fastest and that was more than I wanted but......
@sealavieNSB the sides were cut from a pattern and the center was formed by a heat gun then glued to the sides. It is somewhat flexible but stiffened by flex seal spray then painted.
This is my diy GoPro mount.
I made mine out of EVA foam and aluminum mounting brackets.
Going to show off my diy fender and GoPro mount. The fender is EVA foam covered in a rubberized coating.(
51 here in Utah never skated or been on any board at all. Loving every minute of it!
Made my own fender and carrying handle!