Just add air until it pops on. It may be a very high psi, like 80-100psi.

parrothd
@parrothd
Posts made by parrothd
-
RE: Got hit by a car yesterday.. need advice for getting tire back on rim?
-
RE: What Watches work with OneWheel app & Samsung S8+
@doublebull said in What Watches work with OneWheel app & Samsung S8+:
I've also had the Onewheelwear app drop Bluetooth connection often, I'm now just using the Onewheel app and dealing with the battery drain issue. Maybe it has to do with an older Bluetooth version in my Wear24 watch.
There's no battery drain issue with the wear24, mine lasts a few days. You probably have cellular enabled.
-
RE: What Watches work with OneWheel app & Samsung S8+
@lengthwise said in What Watches work with OneWheel app & Samsung S8+:
@parrothd I'll have to check that out. Does it connect to my iphone or does it connect directly to the onewheel?
Depends on the app
-
RE: What Watches work with OneWheel app & Samsung S8+
Wear24 $60 on ebay, you don't need to set up on Verizon.
-
RE: 99% going down a hill alert -will my board actually turn off ?
Use a cnr setup? Set the battery to a lower voltage so it doesn't charge fully.. 😀
-
RE: CHARGING
@wheelcity said in CHARGING:
@beeasy02
I'm jealous! I live at the top of hill, and would give anything for your problem. Wanna trade?
Seriously though, don't worry about it. Maybe run it down to zero, and back up to 100% a couple times.If you use a crave charger setup you can set the max voltage lower than stock and the board will only charge to that level.. 😀
-
RE: 2 OW's....Way Different Battery Life - Revisited
Ride slower, faster and faster acceleration equals more power means less distance ..
-
RE: Battery capacity and external charging
The bms is only protects for over charging and balancing of the cells. The A123 26650 cellsinside the Onewheel have a max charge rate of 10c which translate to 20amps? The more amps you try to push into the cell more energy is wasted. Doubling the amps only saves like 50% of the time.
-
RE: Portable on-the-go charging of battery question
@sonny123 what battery are you using for 6amp charging?
My 36v 4.4 can't seem to keep up the amps. I thought it was the Onewheel but I think it's once my batt voltage falls the amps drop off..
-
RE: Portable on-the-go charging of battery question
It the same one, just increase the amp setting. The 36v batteries don't have enough mah/volts to charge at 5amps from zero to full. I was planning to run 2 in parallel.
I only have a pic of me trying at 4amps, but I have mine at 5 amps now..