After reconnecting the cables and reassembling board powered up and got the message over charge error 6.

@kazdoom what happen to the issue with the pins?

@mtruby82 Thats the exact model I have its the Vega for OW.

Im not sure how he gets the rim to fit through the tire so easly, I have tried windex, different angles ect. The tire collapses every time I try to push it through. I don't get it..

Lots of footage on how to remove, how do you install the new tire it seems to tight..

Had to go to several shops to get wheel off, bead was almost impossible to break. They could not get the new tire on the rim.

If I was to teach one to use my board I would put it in classic mode so that they cant take off.

My tire in question is on board #2 and it is 2-3 years old and thread baren so I am happy to part with it since I have the new replacement tire, the only difficult part I see is putting the new tire on the rim.

I have heard lots of very interesting ways to remove a old or defective tire, but I am curious if the tire is already damaged, why not just take a knife and cut it open and then use wire clips or similar to cut the bead, yes its messy but you don't need any fancy eqpt or technique to do it just curious.

IF so where are they? And what happens to a plus user if the need new pads and are not for sale on the site?